Quick-reference torque values for M33 bolts across all property classes. Values shown for dry/plain steel, coarse thread. Click any card for full details including all surface conditions.
These values assume dry/plain steel (K = 0.20) and coarse thread. Oiled, zinc-plated, or lubricated bolts require different torque. See full details →
For a typical M33 class 8.8 bolt the dry figure is 2059.8 N·m (1519.2 ft·lbs). If the threads are oiled, drop to 1544.9 N·m — using the dry number on an oiled bolt would push it about 33% past the intended clamp load. Class 10.9 takes 2849.5 N·m, 38% more than 8.8, and the fine M33×2.0 thread raises the 8.8 figure to 2259.7 N·m because its stress area is 10% larger.
M33 is structural and heavy-equipment territory. From M18 up, ISO 898-1 raises the class 8.8 proof stress from 580 to 600 MPa, which is why 8.8 figures step up slightly more than the area alone would suggest. Class 9.8 is not defined above M16. At these torques a 3/4" drive wrench or a torque multiplier is usually needed, and the joint is often better controlled by turn-of-nut or direct tension indicators than by torque alone, because a small change in thread friction moves the clamp load by thousands of newtons.
N·m. Coarse thread unless noted. Clamp load is the 75%-of-proof preload the torque is sized to produce.
| Coarse thread | M33×3.5 |
| Fine thread | M33×2.0 |
| Stress area (coarse / fine) | 693.55 / 760.85 mm² |
| Hex wrench size | 50 mm (ISO 4032) |
| Tap drill (coarse / fine) | 29.5 mm / 31 mm |
| Clearance hole (ISO 273 medium) | 36 mm |
Pitches per ISO 261/262; stress area per ISO 898-1; tap drill = nominal diameter minus pitch. M33 coarse vs fine →